pipeline inspection company

SELECTION GUIDE (click images to navigate)

Pig Trackers are devices that are used to track the passage and pinpoint locate a pipeline pig that is equipped with an appropriate transmitter. These devices enable operating and maintenance companies to minimize the costs involved with excavating and removing stuck pigs.

Four different sizes of transmitters are available for use in small and large pipelines. These transmitters vary in battery life as well as power of their output signal.

Portable wand based systems are utilized to walk a pipeline to precisely locate a stuck pig. These systems allow for visual and audible indication of pig location.

Pig tracking sensors are utilized to indicate the passage of a pig past a given point in the line. This system can be linked to a SCADA package or simply used to provide an easy to see visual indication.

Home | Products | Pricing | Literature | Contact PIC

Model 715

Designed especially for FBE and thin film coatings. It provides infinite voltage settings over the 1,000 - 5,000 volt range

Model 725

For thicker coatings such as coal tars, extruded and tape coatings. Voltage range 1,000 to 15,000

Model 735

High Voltage Range 15,000 - 35,000

Model 915

Shoulder type model for use on thin film coatings. Voltage range 1,000 - 5,000

Model 925

Shoulder type model for inspecting coal tars, extruded and tape coatings, as well as thin film coatings. Voltage range 1,000 - 1,500

Model 670

For paints and coatings 1 - 20mils thick. 67.5 Volts

Model 115

For FBE and thin film coatings. Voltage range 1,000 - 5,000

Model 125

For tape, extruded and coal tar type coatings. Voltage range 1,000 - 15,000

Model 673

For paints and coatings 1 - 20mils thick. 67.5 Volts


Installed on a reinforcing bar (rebar) coating line, the MRSB system continuously monitors the coating as the rebar runs through the RBRS dual roller wet sponge electrodes unit. 67.5 Volts

Model JM

Measures both pulse and DC voltage output. 1,000 - 35,000 Voltage range.

Model PJM

For high voltage pulse output detectors. 1,000 - 15,000 Voltage range.


Measures output voltage of DC Holiday Detectors. 1,000 - 5,000 Volts DC.

Electrodes are offered in a wide variety of types.Spring electrodes are normally used in the inspection of pipes, although full and half circle brush electrodes can also be used. Flat brush electrodes are typically used for flat surfaces and irregular surfaces as they will conform to any shape. Brush materials can be of brass, steel or conductive neoprene construction. Internal electrodes are for testing internal pipe coatings.

Full Circle Spring

Flat Conductive Brush
Flat Steel Brush

Pig Type Internal

Flat Brass Brush

Hand Paddle Brush

Half / Full Circle

Half Circle Brush